Used Woodworking Machinery CONTACTS MACHINERY, INC.
200 Round Lake South, Montcalm,
Quebec, Canada, J0T2V0
PHONE: 866-514-0890
Contact Us About This Machine


Dimter Opticut 104 R Optimization System

Used Dimter Opticut 104 R Optimization System | Saws - Optimizing Cross Cut




 
Machine Information Sheet Date: 8/14/2018
Inventory #: C3499TS
Machine Type: Saws - Optimizing Cross Cut
Manufacturer: Dimter
Model: Opticut 104 R Optimization System
Year: 2001
Region: Central Canada
Voltage: 575/3/60
Can be transformed to required voltage for a nominal fee. Single phase available thru a phase converter.
Condition: Good
Machine Capacities: DESCRIPTION OF OPTIMIZATION SYSTEM

MARKING SECTION

The marking section, which is attached to the transport section, can handle boards up to 20 feet long.

IN-FEED SYSTEM

The in-feed system consists of a precision, servo-controlled pusher arm that travels along the full length of the board, measuring length, grade zones and defects. The pusher arm automatically positions it self after measuring the board and then precisely feeds the board into the saw.

Machine in-feed parameters:

Board Length 3" minimum - 14` 9" maximum
Board Thickness 3/4" minimum - 4" maximum
Board Width 1" minimum - 13.5" maximum
Board out-feed length 20` maximum
Board cross section .75" x 1" minimum - 4" x 13.5" maximum

Machine specifications:

Working height - 35"
Wood species - Soft/Hard Wood
Electrical input supply - 575/3/60
Machine accuracy - +/- .008 inch (New)
Dust extraction - 100 Ft./Sec
Compressed air connection - 1" NPT with 1/2" connection
Compressed air pressure - 100 lb.in2
Operating temperature range - 40-104F
Operating humidity range - 10 to 80%

The heavy 3,500 lbs. GreCon Dimter Opticut 104 saw unit uses 2 pneumatically operated side hold-over rollers before and after the saw blade. A computer-controlled hold down pressure shoe assembly is also used to ensure that boards are secured in position during the cut cycle. These hold down and hold over devices and the precision servo-controlled push arm provide a square, accurate, high quality saw cut.

saw blade drive motor 10 hp
Saw blade - 520mm (20.5") diameter with a 30mm bore
Saw blade speed - 2,900 rpm

Safety devices on the infeed if activated will stop the machine from operating to prevent operators from any harm from any moving parts or boards. Electrically inter-locked covers and doors to protect the operating personnnel generally. Access can be gained to the electrical and mechanical sections of the saw unit via electrically interlocked doors and covers.

Outfeed Table
Non-driven metal outfeed supporting slide table, 8ft long, for manually sorting finished work pieces.

SPECIFICATIONS ARE BASED ON THE SAW UNIT WHEN SOLD NEW.
Sales Price: $46,125.00 CDN
Approximate Monthly Lease: $808.43 CDN
Approximate monthly payments are based on approximate lending rate considering 1st and last month down payment, 60 month term and $1.00 residual buy back. This approximate monthly payment amount is for budgetary purposes only. Based on US leasing rates.

Contacts WW Machinery, Inc. sells pre-owned machinery on a first come, first served basis. Pre-owned machinery is not covered under any warranty or Government requirements. It is purchased "as-is - where-is, with all faults." Descriptions and specifications are to the best of our knowledge (some information is communicated via third party sources). It is strongly recommended that the machinery be inspected prior to purchasing to confirm the condition and specification. Additional charges such as crating and loading may apply.