Used Woodworking Machinery CONTACTS MACHINERY, INC.
200 Round Lake South, Montcalm,
Quebec, Canada, J0T2V0
PHONE: 866-514-0890
Contact Us About This Machine


Doucet SRX-8-8.5-48-32 R

Used Doucet SRX-8-8.5-48-32 R | Clamps - Clamp Carriers




 
Machine Information Sheet Date: 7/17/2018
Inventory #: C4002TS
Machine Type: Clamps - Clamp Carriers
Manufacturer: Doucet
Model: SRX-8-8.5-48-32 R
Year:
Region: Eastern Canada
Voltage: //
Can be transformed to required voltage for a nominal fee. Single phase available thru a phase converter.
Condition:
Machine Capacities: -Rotating frame
-Hydraulic power unit
-Hydraulic tightening tool with joystick control, and built-in torque control valve mounted on a sliding carriage moving across the front rest of the clamp carrier
-Hydraulic rotation motor and speed reducer with joystick forward/reverse control
one valve for tightening torque calibration relative to material thickness and center to center spacing on clamps (as per pressure charts); for a perfect control over tightening pressure regardless of panel thickness
-Pneumatically actuated front rest and section support
-Panel flattener installed on a sliding carriage with flattering and release commanded by a manual rocking valve, downward force of the panel flattener up to 750 lbs
-Light compressed air consumption only 3 CFM
-Width 8.5 with 8 section with 6 clamps to 32 by 2
Sales Price: $16,500.00 CDN
Approximate Monthly Lease: $290.07 CDN
Approximate monthly payments are based on approximate lending rate considering 1st and last month down payment, 60 month term and $1.00 residual buy back. This approximate monthly payment amount is for budgetary purposes only. Based on US leasing rates.

Contacts WW Machinery, Inc. sells pre-owned machinery on a first come, first served basis. Pre-owned machinery is not covered under any warranty or Government requirements. It is purchased "as-is - where-is, with all faults." Descriptions and specifications are to the best of our knowledge (some information is communicated via third party sources). It is strongly recommended that the machinery be inspected prior to purchasing to confirm the condition and specification. Additional charges such as crating and loading may apply.