Used Woodworking Machinery CONTACTS MACHINERY, INC.
200 Round Lake South, Montcalm,
Quebec, Canada, J0T2V0
PHONE: 866-514-0890
Contact Us About This Machine


Paul MK 11

Used Paul MK 11 | Saws - Optimizing Cross Cut





 
Documents Related to this Machine:
Footprint drawing
Footprint drawing
Machine Information Sheet Date: 12/10/2018
Inventory #: C4082TS
Machine Type: Saws - Optimizing Cross Cut
Manufacturer: Paul
Model: MK 11
Year: 2007
Region: Eastern Canada
Voltage: 600/3/60
Can be transformed to required voltage for a nominal fee. Single phase available thru a phase converter.
Condition: Very Good
Machine Capacities: -Feeds the marked timber through the measuring station where its full length is measured and scanned for crayon marks. The board will be optimized according to the data obtained and the cutting list by the controller.
-Defect cutting
-Partial and full optimization
-Saw motor: 5.5 kW
-Feed motor: 4 kW
-Minimum cutting time: .23 sec
-Maximum feed speed: 3.35 m/sec
-Maximum acceleration: 25 (35) m/sec2
-Maximum number of cuts: 150 per min
-Speed of saw blade: 4350 RPM
-Dust outlet diameter: 2x 125mm
-Dust extraction requirement: 1800-2600 m3/h (at air speed 20-30 m/sec)
-Minimum in-feed timber length: 450mm
-Maximum in-feed timber length: 6500mm / 9500mm with partial optimization
-Timber thickness: 12-90mm
-Minimum timber thickness (with special sensors not included): 3mm
-Timber width: 30-180mm
-Minimum timber cross section: 12 X 30 mm
-Maximum timber cross section: 180 X 45/130 X 75/90 X 90
-Minimum cut length: 130mm (with clamping device)/250mm
-Minimum cut length at end of timber: 180mm
Sales Price: CALL FOR PRICING

Contacts WW Machinery, Inc. sells pre-owned machinery on a first come, first served basis. Pre-owned machinery is not covered under any warranty or Government requirements. It is purchased "as-is - where-is, with all faults." Descriptions and specifications are to the best of our knowledge (some information is communicated via third party sources). It is strongly recommended that the machinery be inspected prior to purchasing to confirm the condition and specification. Additional charges such as crating and loading may apply.