Used Woodworking Machinery CONTACTS MACHINERY, INC.
25 ch. Schippel
Montcalm, QC J0T2V0
PHONE: 866-514-0890
Contact Us About This Machine

Tecnoma XTF 10A

Machine Information Sheet Date: 4/12/2024
Inventory #: C4785TS
Machine Type: Edgebanders
Manufacturer: Tecnoma
Model: XTF 10A
Year: 2008
Region: Eastern Canada
Voltage: /3/60
Can be transformed to required voltage for a nominal fee. Single phase available thru a phase converter.
Condition: Good
Machine Capacities: -Edgebander Tecnoma model XTF 10A year 2008
-Important feature : Spindle moulder at the entrance (Premilling) and corner rounder.
-Feed rate of 13 meters per minute.
-Guillotine for edge of 0.3@3mm in roll.
-Band edge capacity up to 10mm.
-Capacity up to 60mm in panel thickness.
-Pre-milling, spindle moulder with diamond entry, 60mm capacity.
-Double end cut on linear guide.
-Up and down trimmers.
-1 motor corner rounder unit.
-Edge scraper 3mm.

Contacts WW Machinery, Inc. sells pre-owned machinery on a first come, first served basis. Pre-owned machinery is not covered under any warranty or Government requirements. It is purchased "as-is - where-is, with all faults." Descriptions and specifications are to the best of our knowledge (some information is communicated via third party sources). It is strongly recommended that the machinery be inspected prior to purchasing to confirm the condition and specification. Additional charges such as crating and loading may apply.